Enplug Device (4K) - Setup Guide (Landscape Only Image)

Installation

To begin installation:

1. Plug the HDMI cable from your TV/display into the Enplug device.
2. If not using Wi-Fi, plug your Ethernet cable into the device.
3. Plug the Enplug device into a dedicated power source.

Your device should now begin to boot.

Connecting to Wi-Fi

To connect your device to Wi-Fi, you'll need to access device settings.

To do so:

1. After your device successfully boots, you'll see a message reading Press O on the Nvidia controller to start Enplug.
2. Press O on the remote.
3. Press the triangle button to open the Wi-Fi menu.
4. The Network menu will appear on the right of the screen.
5. Select the desired network.
6. Enter the corresponding credentials.
7. If prompted, press O again.

When setup is completed, you’ll see a two-word phrase on your screen. Use this to connect the TV/display to your Enplug account.

Linking the Device to Your Account

• Follow these steps to link the device to existing content.
• Follow these steps to link the device to new content. 

Troubleshooting Your Remote

If this is a new device and your remote doesn't work: 

1. Manually restart the device
2. Wait until you see Press O on the Nvidia controller to start Enplug.
3. Press and hold O on the remote until you see a Connected message at the bottom of the screen.

If your remote is connected, but not working, you may need to replace its batteries.

Note: This will require two CR2032 batteries.

For questions or concerns, please reach out to our Support Team at support@spectrio.com.